3 Axis/ 4 Axis CNC controller TB6560 stepper motor driver board H type
- ship from China
- 3Axis-H Type
- 4Axis-H Type
- CNC controller
- with manual control port
- Place of Origin:
- Jiangsu, China (Mainland)
- 1 x TB656 3Axis or 4Axis H Type CNC controller
- 1 x DB25 parallel cable
- 1 x Fan
- 1 x Fan,4pcs M4 screw
- English user manual will send by mail.
4 Axis CNC controller board TB6560 stepper motor driver board for CNC Router Mill:
CNC stepper motor driver board TB6560 the new chip TB6560AHQ of TOSHIBA, the max ouput peak current can reach to 3.5A , this driver board can drive the 2-phase or 4-phase stepper motor whose current is less than 3A.
The advantages of the TB6560AHQ chip:
1) The vibration of the motor is small and low noise: because of the 2/8/16 resolution can satisfy the different speed.
2) Flush type low heat: The area of the chip can support itself to cool when the current is low.
3) Supports a lot of stepper motors.
4) The advantages in the high-speed running condition.
1. With 3 wire 0.8-3.5A (peak) rated output of two-phase adjustable-current bipolar stepper motor drive
2.Support four microstepping --1,1/2,1/4,1/16
3. With optical isolation and DCDC power supply isolation, the full protection of your computer parallel port and equipment;
4.Using RC +7414 automatic semi-flow,the current automatic reduce when stepper motor stop to down the heat
5.Spindle relay output, easy to use software such as mach3 to control spindle start and stop.
6. 5 wire input control,it can set up limit,emergency,centred,tool setting etc
7. With manual port,and connect with manual control equipment
8.12~36V single switching power supply,microchips to use as a 5V power supply, stable and heat small
9.Interface with a fan, you can add fan under your choice
Question and Answer:
Q1:why other supplier?s TB6560 driver has 3.5A/3A current,but yours is 2.5A?
A :TB6560 chip average output current is 2.5A,peak current is 3.5A,and can drive small than 3A stepper motor,ours 2.5A means the top average output current in real,also it is a long time security value,this is not design problem,it is according to the TB6560 chip self specification.
It is not worthy to save small money to buy a driver board but broken mainboard or lose step and skewing when engraving.
3 Axis/ 4 Axis CNC controller TB6560 stepper motor driver board H type $49.99 / piece $55.55 10%OFF