3 Axis 48V/4.5A CNC stepper kit for CNC Router Mill & 5Axis breakout board interface Board
- ship from
- 4 axis CNC kit
- Breakout board:
- 5 axis
- Driver current:
- Driver microstep:
- 16 microstep
- Driver input voltage:
- Place of Origin:
- Jiangsu, China (Mainland)
- 3 x TB6600 Single axis Stepper Motor Driver
- 1 x 5 Axis Interface Breakout Board V5 type
- 1 x Parallel Cable
- 1 x USB cable
- Breakout board English user manual will send by email.
Dear buyer friends, in order to improve service quality and work efficiency to better serves for buyers, pls cooperate with following:
1) Due to of different policies in each country, when you buy pls tell declared value, to avoid trouble in the customs.
2) Brazil and Argentina friends pls provide your CPF, CUIT number, shipping need it.
3) Russian friends pls provide your full name(3 words name), Otherwise will affect the sign and delivery time.
Thank you to cooperate with us!
3 Axis for medium size Router Mill Plasma or Laser
1. 5 axis breakout board
- It can most connection 5pcs driver and control 5pcs motor in the same time
- It is with 4-wire limit switch to insure our safty movement
- It is with relay port to contro the cnc spindle
- Working voltage is 5VDC and support with MACH3,EMC2,KCAM4 software
2. TB6600 high microstep stepper motor driver
- DC power input type:12V~48VDC
- Output current:0.7A-4.5A stepless adjust
1. As shown abovePOWERIN power input interface, as shown above left negative ultra-right is positive, ~~ 50V input voltage 12.
2. STEP DIRVER PORT is stepping motor interface, from left to right definition A is B +, B -, A +, A ?
3. CTR PORT is input control interface,, from left to right in turn definition is DIR -, DIR +, STEP -, STEP +, EN, EN +
4. MOD SW is working mode selector switch, as shown in figure, from the top to the bottom of a single definition is M1, M2, M3, LATCH, which control the driver the breakdown of the selection and error reset mode
Free, Motor don't lock
A mode,1/2 subdivision
B mode,1/2 subdivision
Free, Motor don't lock
Attention: as shown in figure 3 shows, switch to the left dial is OFF, switch dial the to the right is ON
LATCH: ON: automatic recovery mode, OFF: manual recovery mode.
5. CURRENT is the CURRENT regulation potentiometer, the TB6600T1 panel CURRENT Settings screen printing error, actually should be clockwise reduce minimum to 0.5 A, counterclockwise increases the maximum to 4.5 A.
- Protect form : Overheated protect,undervoltage/overcurrent protectio, lock automatic half current
- Working environment:Temperature-15-40deg Humidity<90%
- It is fit for NEMA17-23 two and four phase stepper motors whose current is small than 4.5A,it also can fit for small length NEMA34 two and four phase stepper motors.
- To avoid use in the oil contamination,dust and corrosive gas environment
- To lay it in a place with good ventilation
- Pls note the connection with right power(+ and -) to avoid broken the driver
- Pls test it when confirm the connection is right
3 Axis/ 4 Axis CNC controller TB6560 stepper motor driver board H type $49.99 / piece $55.55 10%OFF
Euro Aluminium Neck 43mm Spindle Mount Bracket Clamp Spindle Motor Holder from RATTM MOTOR $13.50 / piece $16.50 18%OFF